Ulysse Nardin FREAK [ONE OPS]

Reading Time: 7 minutes

For Dubai Watch Week, Ulysse Nardin has created the Freak ONE OPS, a Freak ONE, but with a twist. The new piece measures 44mm in diameter and is cased in black DLC titanium, complemented by a khaki green palette that informs the special sunray-patterned barrel cover and the watch’s integrated rubber strap pairing.

THE REVOLUTIONARY IMPACT OF THE FIRST FREAK MORE THAN TWO DECADES AGO IS STILL CHALLENGING FINE WATCHMAKING

When it was introduced in 2001, the Freak did more than simply shift expectations of Ulysse Nardin watches: it created a new paradigm in Swiss fine watchmaking.

Mechanical watches coming out of Switzerland at the time had hands that showed the time, a dial for them to sit on, and a crown set into the case flank to adjust them. But the Freak had none of these. With no dial, no hands and no crown, it re-set the industry’s mindset. Could unconventional watch design, backed by huge advances in mechanical movement creation, catch the eye of 21st century watch buyers?

You bet it could.

In the two decades since the Freak first appeared, it’s become a cornerstone of high-end contemporary watchmaking. Technologies it pioneered, chiefly in the use of high-tech silicon to mitigate the stresses placed on some of the watch’s moving parts, have defined industry norms. It may have sat outside the Swiss watchmaking comfort zone back then, but where the Freak went, everyone else followed.

Those early models have turned into collector favourites, while further iterations have amped up the story, often by elevating the Freak’s technical capabilities, sometimes just for the thrill of stretching its boundary-less aesthetic.

Among them, and as its name suggests, the Freak ONE has remained the centre point for the collection. The Freak’s Freak. No dial. No hands. No crown. It epitomises the independent, free-spirited thinking that has always defined the Freak, and Ulysse Nardin.

At Dubai Watch Week, Ulysse Nardin continues the Freak’s story with the Freak ONE OPS – as in “operations”, a khaki and black watch that convey an adventurous inspiration. As before, it’s backed by cutting-edge technology developed in Ulysse Nardin’s independent integrated manufacture, only now with a casual look.

For over twenty years since it breathed into life, there’s still nothing quite like the Freak.

THE FREAK ONE GETS THE CAMOUFLAGE TREATMENT

For Dubai Watch Week, Ulysse Nardin has created the Freak ONE OPS, a Freak ONE, but with a twist. The new piece measures 44mm in diameter and is cased in black DLC titanium, complemented by a khaki green palette that informs the special sunray-patterned barrel cover and the watch’s integrated rubber strap pairing.

The material story continues in the bezel, which is made of Carbonium®, an innovative material with exceptional strength-to-lightness properties that’s produced using the same carbon fibres found in state-of-the-art aircraft wings and fuselages. In fact, Carbonium® is made using offcuts from the aircraft manufacturing process, reducing its environmental impact by 40 per cent compared to other carbon composites. The manufacturing technique is organic, meaning the marbled finish found in the Freak ONE OPS’s bezel is unique to each watch.

Given the watch has no dial, the Freak ONE OPS’s calibre UN-240 Manufacture movement is clearly visible, its flying carousel simultaneously relaying the minutes indication as it rotates on its own axis. Also on display are the oversized oscillator and balance spring, both in captivating blue silicon, recalling the existential role silicon has played in the Freak’s unconventional legacy. The movement is automatic and carries a weighty 90-hour power reserve.

There’s a choice of two integrated straps: one in black and khaki “ballistic” rubber, and an alternate two-tone rubber strap, also in black and khaki. Both have black DLC titanium and black ceramic folding clasps. The straps tell Ulysse Nardin’s environmental story, too. They’re made using 30 per cent recycled rubber from production waste.

The result is a bold, muscular piece that amplifies the Freak’s story of daring design and in-house technical know-how.

THE FREAK [ ONE OPS] IS NO ORDINARY WATCH

NO DIAL
Typically, mechanical watches hide their workings under a dial. But the Freak
ONE OPS has no dial. Its movement doubles as its minute hand, while the
hour hand is a pointer set on a rotating disc that sits under the movement.

NO HANDS
The unconventional Freak ONE OPS has neither a big hand nor a little
hand. Instead, its one-hour orbital carousel tourbillon becomes the
minute hand, and the hour hand is replaced by a pointer on a rotating disc.

MATERIAL ADVANTAGE
The Freak ONE OPS has a black DLC titanium case, topped
with a bezel made of Carbonium®, a material first used in
fine watchmaking by Ulysse Nardin in 2019. It’s produced
under very high pressure and at very high temperatures using
carbon fibre offcuts from the aviation industry, meaning its
environmental impact is 40 per cent lower than other carbon
composites. The fibres measure just 7μm and are weaved
together in an organic fashion to create a unique finish every time.

HANDS DOWN
The Freak ONE OPS is powered by UN-240, a self-winding movement
with a 90-hour power reserve. The movement’s flying carousel with
its silicon balance wheel and escapement are suspended by a bridge
that acts as the minute hand; a second bridge serves as the hour hand.

SEE THE LIGHT
The hour and minute indicators and hour markers are coated in a
beige Super-LumiNova® that glows green in low-light conditions.

THE ORIGINAL FREAK, A FREAK EVENT

THE FREAK’S ARRIVAL 20 YEARS AGO WAS TONIC FOR ULYSSE NARDIN [AND SWISS WATCHMAKING]

By the late 1990s, Swiss watchmaking’s revival was well under way. A number of Swiss entrepreneurs had seized on a fresh cultural air du temps that had a newfound respect for the industry’s heritage and quality, and begun the process of rebuilding a sector that in the 1970s and 1980s had been laid to waste by the onslaught of quartz technology from outside the country’s borders.

One of the visionaries who saw the undimmed potential in mechanical watches was Rolf Schnyder. Mr Schnyder wanted to take Ulysse Nardin’s legacy and reputation for inventive contemporary wristwatches and revitalise it for new-generation watch lovers.

But to do that, he would need a watch that would epitomise and extend the new energy in Swiss watchmaking – and the amped-up ambitions of Ulysse Nardin. What was called for was an upstart design that would shake up a dozy establishment and captivate a new generation of mechanical watch buyers.

Behind the scenes, Mr Schnyder was working with genius watchmaker Dr Ludwig Oechslin on a new kind of watch. It would have no dial, no hands and no crown. Only one name seemed to fit: Freak.

Its launch in 2001 was revolutionary. Not only were the design and engineering groundbreaking (the time was set by rotating the bezel and it was wound via a device set into the case back), the Freak was also the first Swiss watch with an escapement made of a new watchmaking wonder stuff: silicon. Silicon was light and elastic, frictionless, had high resistance properties, and could be produced to very fine tolerances. Today, the use of silicon in watchmaking is commonplace, but at the turn of the Millennium, it was revolutionary. The Freak went first.

And others followed. Over the past two decades, the Freak has appeared in many further guises and also been used as a testbed for experimental advanced technologies. But at heart it remains what it always was: a freak.

---

BACK IN TIME

IN ITS TWO DECADES OF LIFE, THE FREAK HAS CONSTANTLY RESET THE BOUNDARIES OF WATCH DESIGN AND ENGINEERING. BELOW ARE SOME OF THE MILESTONE WATCHES THAT DEFINE ITS STORY.

---

Ulysse Nardin FREAK [ONE OPS] Technical Specifications

Ref. 2403-500-8A/3A – 63’000 CHF (VAT incl.) / 67’500 EUR (21% VAT incl.) / 66’500 USD (VAT excl.) / 58’480 GBP (VAT incl.)

Movement

• Caliber UN-240 Manufacture
• Automatic movement
• Hours, minutes
• Flying carousel movement rotating around its own axis
• Silicon oversized oscillator and balance spring
• DIAMonSIL treatment to escapement
• Grinder® automatic winding system, blades technology
• Frequency 3 Hz, oscillations 21’600 V/H
• Power reserve: 90 hours

Case

• Black DLC titanium case
• Carbonium® bezel
• Green khaki engraved sunray pattern on the barrel cover
• Diameter: 44 mm
• Water resistance: 30 metres

Strap & Buckle

• Integrated kaki & black «ballistic» rubber strap
• Black DLC titanium and black ceramic folding buckle
• Integrated two-tone rubber strap
• Black DLC titanium and black ceramic folding buckle
• Rubber straps made of 30% recycled rubber from production waste

ABOUT ULYSSE NARDIN
Ulysse Nardin is an independent and integrated Manufacture producing advanced timepieces for explorers in pursuit of freedom.
Founded by Mr Ulysse Nardin in 1846, the company owes its reputation to its links with the sea: its onboard marine chronometers are among the most award-winning and reliable ever designed.
A pioneer in innovative technologies and the use of high-tech materials such as silicon, Ulysse Nardin is one of the few integrated manufactures with the in-house expertise to produce its own high-precision components and movements. In 2001, the Maison changed the face of contemporary watchmaking by launching the first Freak.
Today, in the Swiss towns of Le Locle and La Chaux-de-Fonds, Ulysse Nardin remains devoted to its quest for watchmaking perfection in four collections: Freak, Blast, Diver and Marine.
As of 2022, Ulysse Nardin and sister Maison Girard-Perregaux have formed an independent collective of high horology Manufactures.